controler connectio...
 
Notifications
Clear all

controler connection help

4 Posts
3 Users
0 Reactions
1,692 Views
Posts: 6
Topic starter
(@hahaharuca)
Active Member
Joined: 17 years ago
[#7821]

I have just gotten a Paralel port pc relay driver board and i am trying to run my sequences on it and i have a couple questions #1 what add-on's should i use #2 how do i incorperate those add-on's with the controler or does it automaticly detect it if its pluged in #3 when it is pluged on should the LED indecator lights turn on and stay on even during a sequence?

and i might have mixed up add-on's with run-on's witchever one controls the control board


3 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I think you mean 'Plug-Ins'. There should be one for the parallel port driver that you need to configure for which parallel port number you are using.


Reply
Posts: 6
Topic starter
(@hahaharuca)
Active Member
Joined: 17 years ago

I'm not sure which parallel port number it is. Where can i find this information? It plugs into a USB drive. It controls 8 lights. Next to the parallel port it says CN1 if that means anything.


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago
hahaharuca wrote:I'm not sure which parallel port number it is. Where can i find this information? It plugs into a USB drive. It controls 8 lights. Next to the parallel port it says CN1 if that means anything.

Uh-ohhh..... USB parallel port adapters generally don't have enough current to drive much of anything. Does the computer itself have a built-in parallel port in the back of the PC? If so, that's the one to use. If not, then a parallel port solution is probably going to be "iffy" at best...


Reply
Share: