Hello,
We are trying to set up a small Halloween display this year. Last year, my brother built a basic parallel 12 channel controller for a Christmas Show. Since then, I have purchased and Arduino, and would like to incorporate it into the show(I Built some Arduino controlled, Servo-Powered singing pumpkins). The problem comes down to ports. We are using an old laptop for its parallel port, which works fine. When I plug my Arduino in, however, the laptop assigns it to COM7. As far as I can find, Vixen will only read COM 1-4.
I can think of two solutions. One requires switching around COM ports. The thing is I cant find what is using up those ports, and i don't feel comfortable changing it without knowing what im doing. The other idea would be figuring out how to make vixen accept COM7, but im not quite sure how I would go about doing that.
Any help would be awesome!
-Alex
Assuming you're using Windows and the generic serial protocol, go to the control panel and choose SYSTEM. Inside that you'll find the Hardware Device Manager. It will show all the ports/assignments/etc that the computer has. You may have to "uninstall" some that are taking up various comm settings that you need to use, or reassign one that's in the Vixen range to com 8, then reassign 7 for your arduino.
If you're using Linux... well... Call Linus Torvalds...
You would be correct. I am using Windows XP. Under the ports section, the only ones listed are Arduino(COM7): Communications Port(COM1); and ECP Printer Port(LPT1). I cant find any hiding in the other folders either. But when I go to change the port, it says 1-7 are in use.
Click View - show hidden devices and look through "Network adapters", "other devices" and "sound,video and game controllers" and see if com 7 is being used there. If not, then...
... this gets a little dangerous but take a look at the registry. First, make a system restore point so you can get back to where you are now in case something goes bad... If you've never done that, click Help - type Restore Point in the search box and you'll get a link to "Creat a Restore Point." Then...
Now, unplug your Arduino.
Click START - RUN and type REGEDIT in the run box. The registry editor will pop up.
Open HKEY_LOCAL_MACHINE, then open Software, then open Microsoft, then WindowsNT, then CUrrentVersion, and finally Ports. You should see all the ports Windows thinks are there. Mine go all the way up to Com14. If you really and truly don't have a hardware COM4 port, delete it. Also delete COM7 so your Arduino has to find a new one.
Exit the registry editor.
Now plug in your arduino and see if it finds com4. If not, restart the computer and try it again.
Hopefully it will find the first available one, which is com4.
May the force be with you.
No need to hack the registry. Just go into the device manager and move the com port number assignment in the advance properties.
