Adjustable preview ...
 
Notifications
Clear all

Adjustable preview problems with 2.5

6 Posts
4 Users
0 Reactions
1,734 Views
jcizek
Posts: 160
Topic starter
(@jcizek)
Estimable Member
Joined: 19 years ago
[#8547]

Hi all,

I am trying to build a new sequence from scratch in Vixen 2.5. I have setup all my channels, named them, changed their colors etc... I setup adjustable preview, loaded the house pic, and painted my pixels for all the channels. When I step through them, the correct pixels are being highlighted, but when I go and "play" the vixen sequence, the house pic pops up, and MOST of the channels do not highlight any pixels while it's playing. Some work fine, but most do not do anything to the picture. I have never had this happen before and I am sure i am missing something simple.. I finally gave up and decided to ask here for any suggestions.. 😎 Thanks!
-James


5 Replies
Posts: 1062
 Ronp
(@ronp)
Noble Member
Joined: 20 years ago

did you setup a profile?If so is the sequence running from a old profile thay you had before all the channels were edited


Reply
jcizek
Posts: 160
Topic starter
(@jcizek)
Estimable Member
Joined: 19 years ago

I am running a profile, but I set it up fresh in this version. I started everything from scratch on this version. I have 177 channels configured, but I have only found about 6 of them that will actually display on the preview while playing the sequence. They ALL display on the preview in the preview setup screen just fine though....


Reply
jrock64
Posts: 1099
(@jrock64)
Noble Member
Joined: 19 years ago

What size is the photo you are using in the preview?
Smaller is better.
Try removing the photo.

Joel


Reply
jcizek
Posts: 160
Topic starter
(@jcizek)
Estimable Member
Joined: 19 years ago

I was using a small photo... used picsizer to shrink it first...think it's about 10k on disk (as I know vix repaints the entire picture each change). I tried removing the picture altogether and running... When I hit play, the adj preview box pops up (this time all black with no picture in it) and absolutely nothing displays at all, not even the few channels that were working before.. I have remade the profile, reset the adj preview setup.. nothing is working. Getting very frustrated with this... I went back and built this same profile and setup adj preview in vixen 2.1 and it works prefectly, both with and without the picture. I am getting frustrated with this (but really wanted to use 2.5 for dimming curves...)


Reply
Posts: 864
(@deplanche)
Noble Member
Joined: 19 years ago

Are you sure the adj. preview is set for the correct number of channels. I find I make this mistake very often.


Reply
Share: