I have a very strange issue. In our show we have a channel with three snowflakes LED's. Randomly during the show one of the snowflakes in this channel blinks. We have watched over and over again and do not see a pattern as to when it is flashing. We've checked the sequence for extra programming and nothing is there. How do I start to figure out why this one snowflake is blinking?
Running Vixen 2.0, Ren 24ss
make sure there are no wires touching where you screw them into the lugs
I had a same issue and it was a tiny piece of steel wool
The first thing I would do, would be to reflash the PIC. Then check for shorts as mentioned above if that does not fix it.
TazViper10 wrote:How do I start to figure out why this one snowflake is blinking?
Try moving it to another channel on the same controller, or onto another controller to see if the problem moves with the snowflake or stays with that channel or SSR. That will help isolate where the problem is.
don
OK... gotta ask... Are you sure this is not a blinking snowflake by design? I have the incan style snowflakes and they have a blinker bulb on them that I have to remove. Sometimes it's the easy things... Does it blink off (then back on) when it should be on?
If it blinks on when it should be off, then it can't be a blinker setup...
Thanks for all the ideas. No the snowflake is not blinking by design. We have used it static for 2 years now. And through a total of 5 shows it only blinks twice. We have reflashed the PIC and checked for all shorts. It is just really strange because three snowflakes are plugged into each other but only the one blinks.
Hi TazViper10 - I know this probably sounds dumb, and you've probably already checked - is it possible there might be a broken or faulty wire in the snowflake that might be intermittently making/breaking contact, perhaps with the wind or something?
-Robert
