Static when playing...
 
Notifications
Clear all

Static when playing a vixen sequence

8 Posts
6 Users
0 Reactions
3,007 Views
Posts: 111
Topic starter
(@dadams14)
Estimable Member
Joined: 19 years ago
[#4471]

I have songs scripted and when I run them on VIXEN I hear static on my radio along with the music. I tried all sorts of noise suppression, but still static.
I shut down VIXEN and used meda player and played the same music and it is static free.. Anybody know if running VIXEN will cause static in the music?
I have to fix this or it will shut me down for Christmas.
Thanks in advance
Dennis


7 Replies
Posts: 111
Topic starter
(@dadams14)
Estimable Member
Joined: 19 years ago

I meant WINDOWS MEDIA player.
Sorry


Reply
Penfold
Posts: 1235
(@penfold)
Noble Member
Joined: 19 years ago

What you can try to do is put Ferrite beads on the cat5 going out to your light controllers. I believe I read that somewhere or heard that this could interfere with the FM transmitter causing that static.

I'm sure the seasoned verterans (Electronic Wizards):wink: would have better advice to give, but that is what I can think of off the top of my head.


Reply
Posts: 57
(@flowblok)
Trusted Member
Joined: 19 years ago

Try running it in Vixen, without the transmitter.
If you can hear static, then it's a problem in Vixen.
If you can't hear static, then it's a problem with the transmitter. Things to consider:

  • (Above post)
  • Quality of cabling
  • Strength of signal from transmitter - try putting your radio really close to the transmitter.

I'm not an "electronic veteran", just a computer programmer - so I'm sure that they've got better suggestions than me!


Reply
Posts: 854
(@terbobob)
Noble Member
Joined: 19 years ago
try putting your radio really close to the transmitter

also , try putting your transmitter further away from your PC .


Reply
Posts: 529
 Josh
(@josh)
Honorable Member
Joined: 19 years ago

also check your input power(volume) as cheaper transmitters will cause static if its too high


Reply
Posts: 111
Topic starter
(@dadams14)
Estimable Member
Joined: 19 years ago

The problem was caused by a pc with poor shielding. The Hard drive was very niosy and got into the audio. I had another PC and swapped it in and problem was solved.
Thanks to all who answeed


Reply
Posts: 234
(@dhavard)
Reputable Member
Joined: 19 years ago

Ok, I am having a similar problem. When a sequence is running and I have almost all the lights on at one time, I get static over the FM transmitter. I have tried moving the Transmitter close, far away, and I have tried ferrite beads. Nothing seems to help. I have also tried lowering the volume on the pc too. I even moved where the fm transmitter is plugged in and still get it. Any ideas on what to try?


Reply
Share: