I just found out about vixen, saw a link in a page about making a weather display and I was wondering if it supports multi-port boards.
I did a search but didn't see anything.
I have a couple of old multi-port serial cards and a 4 port parallel card and will probably do something with an older computer I got sitting around.
I have some lcd displays I'm going to get working on a pc parallel port, so vixen mite work for that, as I'm not the big programmer. I can butcher a simple program someone else has made, but I'm not to good writing one on my own.
Hello And Welcome
About your question:
For multi-port serial I can say yes as there are several users here that run vixen with multi-port serial cards.
But I am unsure about multi-port parallel cards.
Bill
Vixen will work fine with multi port serial and parallel cards. The only issue with some parallel cards is that the voltage is sometimes quite low, and some 595/grinches will have problems reading the high's, but there are some ways around this issue. Adding a ren-c and running them on a serial port is often an easy fix, plus you get dimming as a bonus 🙂
thanks for the info
So what exactly is a "595/grinches"
olsen 595 or the grinch Both have 64 ch per controller Basic on of control the olsen 595 uses 8 595 shift register chips 8 channels per chip with 8 moc 2803s to control the relays... The grinch uses 4 allegro chips witch are the same as the 595 and 2803s built into the same chip 16ch per chip
the 595 board has 64 leds and the grinch dont Grinch is cheaper to build
read this to see more http://www.doityourselfchristmas.com/wiki/index.php?title=Comparison_of_DIY_Boards
