The computer I'm using this year seems prone to rebooting during my show. I have it set to autologin and start Vixen if that happens. When it does that during non-show hours everything seems to run fine. The problem comes if it restarts during a show - the show timer has already passed the start time, so it just sits there until the next evening. Is there any way to make the timer reset by itself? Perhaps if Vixen is started up during show hours it will automatically start playing the show?
It sounds like you have one large program that runs once and you only set the start time, correct? Did you select "repeat until"? Try setting the "repeat until" time for the latest time you would like the show to restart. There is no why to make Vixen pick back up where it "should be" if it had started at the original start time - it just runs the entire program frokm beginning to end.
Maybe you could divide the scheduled program up into each of it's sequences and say when each would start - then it would kinda pick up where it left off when the PC re-booted.....
I have one program with 5 sequences. The program is about 14 min and 40 seconds long and repeats from 5-9:30 each night.
I know with LOR if the computer restarts during show hours it will start playing from the beginning and still cutoff at the correct time.
Vixen will do that except for cut a program off in the middle. Once it starts, it will run to the end - even if that is past the "repeat until" setting. Are saying that the repeat until setting is not starting the show again after the reboot, even though you are still in the start -> repeat until window?

Set like this, it does not start the show if Vixen is loaded after 5:00pm. If Vixen is loaded before 5:00 is runs fine.
What version of Vixen?
Well, I stand corrected! I just went stopped Vixen and it did not re-start my repeating program when I re-started Vixen. I swear I tested this, but this evening, it is not working as I expected it to. I recently added background sequences and music. Let me turn those off and see what happens...
....nope, no change! Hummmm.... I thought I understood that scheduler timer. Obviously, I don't....
The only why to get it re-started is to select the recheck current timers menu option....
Vixen 2.5.0.8 - anyone have any differnet information?
I am sorry, Larry - good thing we didn't bet or you would have won!
Ok, I just figured out how I misled myself on the timers. If you touch a schedule and set the start time in the past, once you save it, the timer will run shortly after you close the scheduler. But if Vixen re-starts, it only runs the timer at the original start time. I assumed (we all know what that does) I was testing the case where Vixen re-launched, but I wasn't. Touching the schedule must also re-check the current timers....
..So, Larry has accurately described Vixens behavior...
I am confused. If a solution has not been found I have a solution.
When I created my show it was nearly 29 minutes long. I then went and created an extra sequence that made the program 29 minutes and 59 seconds long.
I then went and set the schedule to run on the hour and the half hour. This way, if the computer rebooted, within half an hour the time would pass a trigger point and start again.
Jon
If for any reason Vixen shuts down a program while the timer is running it does not automatically restart the timer. The only thing your can do is go up to the menu, select programs and restart current timers. If something is set to run it will restart the program from the begining and shut it down at the end of the program after the timer runs out.
As far as I know there is no way to have vixen restart a timer by itself after it has shut off
The far deeper problem is why do you have a computer that reboots itself? Sounds like that would be the problem I would want to fix. My show computer has been on since Thanksgiving and I beleive I have only had to reboot once to correct a com port error that I caused myself.
