Sequence Locks Up
 
Notifications
Clear all

Sequence Locks Up

21 Posts
10 Users
0 Reactions
37.9 K Views
rstehle
Posts: 4348
Topic starter
(@rstehle)
Illustrious Member
Joined: 19 years ago

No, I don't have any issues when I run the channel test, but I have begun to get the event thread error sometimes if I let a sequence run to the end.


Reply
Posts: 110
(@jmelvin)
Estimable Member
Joined: 19 years ago

I am not getting any error messages but vixen is lagging. I start a sequence then hit pause to edit but it keeps playing for about 10sec and then stops. Also if i change something the preview is not updating. I have to close the preview for it to refresh. This happens on either of my computers.


Reply
Posts: 9
 k0s
(@k0s)
Active Member
Joined: 18 years ago

might be same bug:

got the 3 K8055 boards up and running (see other thread), but since the last update v2 crashes when i hit play.

resolved:

i had to remove the TRIGGER plugin(s). at my side only the one k8055trigger.dll

regArts
k0s


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago
jmelvin wrote:I am not getting any error messages but vixen is lagging. I start a sequence then hit pause to edit but it keeps playing for about 10sec and then stops. Also if i change something the preview is not updating. I have to close the preview for it to refresh. This happens on either of my computers.

This sounds like the picture in the preview is too large.


Reply
kostyun
Posts: 2178
Guest
(@kostyun)
Member
Joined: 20 years ago

This also describes the problems I've been having my open dmx clone also.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago

This appears to be a serial issue.


Reply
Posts: 12
(@sirwesley)
Active Member
Joined: 18 years ago

Having similar issues, however, for me Vixen hangs when I hit "STOP" after a "PLAY", seems a little odd since a "PAUSE" after a "PLAY" works fine. After hitting "PAUSE" I can then hit "STOP".

I did not update...so I'm running 2.0.5


Reply
rstehle
Posts: 4348
Topic starter
(@rstehle)
Illustrious Member
Joined: 19 years ago

Have you installed the new updates that KC posted? They have helped a lot of folks with similar issues.


Reply
Posts: 12
(@sirwesley)
Active Member
Joined: 18 years ago
rstehle wrote:Have you installed the new updates that KC posted? They have helped a lot of folks with similar issues.

I just installed with the updates provided by KC. Same issue. I also seem to have an issue stopping a "program" from running too. I can pause and resume, but the minute i hit the stop button, Vixen freezes and have to pull up the task manager to close it. No exception is thrown.


Reply
Posts: 919
(@scorpia)
Noble Member
Joined: 19 years ago

do a search for the 2.0.5 beta. there was also a 2.0.5 release which was different .

get the beta and dont update it. this seems to be the version most people are having luck with.


Reply
Page 2 / 3
Share: