Schedule Error: Obj...
 
Notifications
Clear all

Schedule Error: Object reference not set to instance object

15 Posts
8 Users
0 Reactions
19.6 K Views
Posts: 110
(@jmelvin)
Estimable Member
Joined: 19 years ago

KC I know your very busy. I was wondering if you were able to recreate the problem and if so what caused it? Ever since I did what I said in the last post everything is working great.


Reply
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 20 years ago

Guys, Make sure you enable "Hold Port Open" in the Renard Serial setup. I was having the same issues and that simple step solved them all.

In addition to that I am using Phil's modified Renard plug in, did a fresh install and made new sequences instead of using the converted ones.

see this thread http://www.doityourselfchristmas.com/forum/viewtopic.php?t=1682


Reply
Posts: 110
(@jmelvin)
Estimable Member
Joined: 19 years ago

Brian I think our issues are different. I didn't have hold port open checked before or now and I'm not having any problems now that I resequenced that particular song. I used the same profile as before just a new sequence file. Actully holding the port open caused errors that the port was in use.


Reply
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 20 years ago

I was just going by the description in the OP.


Reply
Posts: 70
(@brad-h)
Trusted Member
Joined: 19 years ago

Did this issue ever get resolved? I am having the same problem with one system. Must have "leave port open" un-checked or crashes with port error. Get this object error on occasion (sometimes it runs for hours with no crash - other times it will crash in less than one hour). After clicking OK it continues - but what if I am not home to do that?


Reply
Page 2 / 2
Share: