Notifications
Clear all

Com port bug

4 Posts
3 Users
0 Reactions
4,057 Views
Posts: 50
Topic starter
(@skygodtj)
Trusted Member
Joined: 19 years ago
[#5079]

I'm trying to get my Enttec DMX Pro to work with Vixen... any version of Vixen that'll support the DMX Pro... Vixen versions 2.05 to 2.09 won't let me use the com port that the dmx dongle is on.. I'm continually getting "Com x does not exist" when I try to run a sequence.. I started with 2.09, then went down to 2.05, even tried 1.11 (but no DMX support) ..

Using the Enttec Utility, I can confirm that the dongle connects, is recognized, it tells me the D2XX driver loads and the Com port button tells me that the dongle connects to Com X.. So it does load, and get a com port, just not IN Vixen..

I uninstalled the Enttec driver version I had and installed 2.04.06 (could've been the same). No change, Com port still 2, USB Serial Port 7 and Vixen still says "Error when loading addressable DMX", then "Enttec DMX Pro: Access to com port 7 is denied" when I start Vixen again.

WinXP Home, SP3, .Net Framework 2.0 and 3.0 installed,
WinXP Device Manager:
Ports: (Com & LPT)
Comunication Port: Com 2
ECP Port (LPT)
USB Serial Port: Com 7

Here's what I get to choose from:
Com port 1 (in use)
Com port 2
Com port 3 (in use)
Com port 4 (in use)
Com port 5 (in use)
Com port 6 (in use)
Com port 7
Com port 8 (in use)
Com port 9
Com port 10
Com port 11
etc...

Any ideas?

Thanks, TJ


3 Replies
jrock64
Posts: 1099
(@jrock64)
Noble Member
Joined: 19 years ago

Just a bad guess.

Do you have the DMX Add in checked.

Joel


Reply
Posts: 50
Topic starter
(@skygodtj)
Trusted Member
Joined: 19 years ago

Good morning Joel,

Yes, create a Vixen standard sequence,
set up plug-ins: Enttec DMX USB Pro,
Use,
click on it,
Plug-in Setup,
choose serial port (7), 115K, 8, N, 1,
OK,
Done.
Next.
Pick audio clip.
Next, Next, Create It.
Name it.
I get "Verifying DMX Pro" when events screen appears.
Add-Ins,
Waveform,
choose On-Off channels(make it simple),
Ok,
Visualizer,
Done,
Play,
"Enttec DMX Pro: Access to Com 7 is denied"..

happens each and every time =(

TJ


Reply
Posts: 121
(@vairmoose)
Estimable Member
Joined: 19 years ago

One of the early glitches that I ran into when I first tried the DMX dongle was that the Windows Device Manager kept loosing the information on speed ... i.e. i'd go check the device manager settings and speed would have been reset to some obnoxisouly low number like 5400 baud.

you may want to double check the Windows Device Manager to make sure that it is displaying the same baud rate and comm port info that you are using in Vixen.

Larry


Reply
Share: