Basic Parallel Ques...
 
Notifications
Clear all

Basic Parallel Question

5 Posts
4 Users
0 Reactions
2,147 Views
Posts: 3
Topic starter
(@nickf1195)
Active Member
Joined: 19 years ago
[#1834]

Channels 1-7 have lights plugged into them. I have a radio transmitter plugged into channel 8 and want to make it turn on at the beginning of the show each night. I disabled channel 8 in the "Enable/Disable channels for this sequence" button in all my sequences. I then attempted to make a scripted sequence to turn on channel 8 and put it in the schedule right before the show starts. I can't get that to work either. 😥

Any suggestions are welcome!

Thanks,

Nick


4 Replies
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 20 years ago

Nick,
A scripted sequence will only run as a background sequence if there is nothing else running. I do not think you can run 2 sequences at once, especially using the same port.

Sorry but it is not going to work the way you are intending. I just leave the transmitter on 24/7 and the music turns on and off with the schedule. One member wound up frying his walwart for the transmitter by trying to do the same thing, putting it on a relay.


Reply
daviddth
Posts: 925
(@daviddth)
Prominent Member
Joined: 19 years ago

I did a test here Brian, and switched plugpacks (240V to 24V - you call them wall warts), and within a few minutes of switching I had destroyed one & 2 others were looking pretty overheated. That was just turning them on & off in 2 second blocks via vixen and my SSR's

I would not suggest switching them again to anyone, which is pretty much along the same lines as your post.


Reply
Posts: 3
Topic starter
(@nickf1195)
Active Member
Joined: 19 years ago

Thanks for your replies. I was trying to turn the transmitter off and on because the manual says so. I guess leaving it on is better than trying to do this!

Once again, thanks for your help.

Nick


Reply
XmasInGalt
Posts: 526
(@xmasingalt)
Honorable Member
Joined: 19 years ago

I use a X10 controller and a appliance module to turn the power off 20 minutes after the scheduled end of the show.


Reply
Share: