Using Perfboard
 
Notifications
Clear all

Using Perfboard

2 Posts
2 Users
0 Reactions
2,004 Views
Posts: 59
 mark
Topic starter
(@mark)
Trusted Member
Joined: 19 years ago
[#3858]

i'm considering using perfboard for my controller and ssr's. would this be good for an installation or would it be considered unsafe?

thanks!


1 Reply
Posts: 274
 Matt
(@matt)
Reputable Member
Joined: 19 years ago

For controllers safety shouldn't be an issue. For your SSR's, make sure you use some bigger diameter wire in places that carry loads at line voltage, or beef up the traces with a lot of solder. In any case, using a fuse that blows at an amperage that will protect your traces/wires.

More of a concern than safety is your time. I can't overstate that it is MUCH easier and quicker to get a PCB from a Group Buy or another member here and solder it up. The saved time was definitely worth the investment for me. Also, the use of PCB's was one of the main factors that made my 2007 display work and my 2006 display (using perfboard) unreliable. Nowadays with the size of the community here, PCB's for your designs don't cost all that much more than perfboard anyway.

-Matt


Reply
Share: