Starting with pixel...
 
Notifications
Clear all

Starting with pixels.

10 Posts
6 Users
0 Reactions
9,137 Views
Posts: 8
Topic starter
(@herschelwtacos)
Active Member
Joined: 7 years ago
[#50956]

I bought 20awg wired 12v pixels and I am scared I messed up. I just now watched a video on YouTube about the differences in 18awg and 20awg.
I was planning on using a falcon f48 and running 200 pixels from the differential receivers without power injections. Now I think because I cheaper out on wire size I'll have to power inject. What is your guys and gals advice on best route to go from here?


9 Replies
Posts: 317
(@dvc2013)
Reputable Member
Joined: 14 years ago

It really depends on many things. But with 200 pixels you will likely need power injection even with 18ga. I think a general rule is about 100 pixels before power injection at 12 volts. It drops to 50 at 5 volts. There are many threads here on the forum on this topic.

FYI, the most I have been able to get with my 12 volt pixels with18ga wire is 108. Any more than that and the results start to deteriorate pretty fast. Although some people have been able to get more.

just my opinion.


Reply
Posts: 401
(@kensington)
Reputable Member
Joined: 11 years ago

As a rule of thumb, power injection with LEDs is a fact of life for anything over 100 12v LEDs. Learn to love it. Just run a power cable from your PSU to the end of the 200 LED strand, and you’ll be fine.

Oh, and when only the first 50 pixels light up when you power it on, check the pixel count on your Falcon setup.


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

Yes @ 200 pixels you will need to power inject, but you can do it at the end of the run to simplify things. Also running you pixels at 50% brightness (some go to 30%) can extend the how many you can run before need to power inject, I have couple runs about 145 that are fine w/o. You really just need to test your to see.


Reply
Posts: 486
(@uncledan)
Honorable Member
Joined: 11 years ago

The only way to know is to test it. If you limit intensity to 20-30% it might work out. I run my show at 30% or less anyways. I go 300+ pixels powered from one end @20% with no issues with 18AWG. Lower the intensity on the output and test. If its yellow towards the end of the string lower intensity more. People rarely use all white so if it works with all white at a reduced intensity it will work for your show. FYI you cant power 200 pixels at 100% intensity from the Falcon anyways. It will blow the fuse on the output


Reply
Page 1 / 2
Share: