How to start correc...
 
Notifications
Clear all

How to start correctly

5 Posts
4 Users
0 Reactions
5,227 Views
Posts: 2
Topic starter
(@sybux)
New Member
Joined: 9 years ago
[#47862]

Hello everybody,

I've decided to build for next year a beginning release of a Christmas house :biggrin:

I've read the beginning guide but I'm not sure to be sure of everything.
For beginning, I'll build a Mega-Tree for let's say 25 string of 50 bulbs.
I've already downloaded and installed Vixen3 and play a little bit to create sequence.
For controlling all the system I'd like to use a Raspberry 3 with Falcon Player Sequence

Where I'm a little lost is the part concerning the Controller. I've watched Matt Johnson video where I can see him using SanDevice e682.

My actual questions :
- Should I use a big controller for all the light show item I will have a the end or should I use little one by item ?
- Is my topology correct or is it missing some parts ?
- Is there a link somewhere to explain a full schema from the computer to the light ?

I thanks everyone who will answer this post and help me to go further on my job.

Merry Xmas and happy new year to all.


4 Replies
Posts: 631
(@stampedeboss)
Honorable Member
Joined: 13 years ago

I personally believe smaller controllers that limit cable runs are better than a large controller with runs all over the place. I recommend laying out what goes where then determine best trade off for controller size. I have found the 4 port controllers offer better density. I use the larger controllers for Megatrees and an area with a large number of props.

One other thing to consider is how much power injection do you want to deal with. You can most often trade off having to do injection by not fully leveraging ports.

Sent from my iPhone using Tapatalk Pro


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

It depends. A typical show uses a 25ms refresh rate. This means a single port on any controller should not have more than about 600 pixels on it (more than that and you cannot meet the refresh rate). I prefer more controllers around the yard with fewer wires running about (there are still a lot but not as bad as with central controllers). Next you need to look at the prop density you plan to have in an area and decide the size of controller needed to support those props in that area. I ended up with four F16s and a bunch of other smaller controllers. I keep the load on the WiFi very light so most of my show is hooked up via CAT5. I have two FPPs that run various aspects of the show (designed to keep network traffic segregated and low lag on the network). Some stuff is on the house, on the roof, up in trees or even on the ground. There is no hard and fast rule. Decide what type of mess you want in the yard and then design around keeping it contained.


Reply
Posts: 2
Topic starter
(@sybux)
New Member
Joined: 9 years ago
MikeKrebs wrote:are you thinking about only pixels or are you going to use ac lights as well?

As I will start small, I'll keep my AC lights


Reply
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

There is a good guide on the xlights website comparing a bunch of controllers. I'm a Falcon proponent. Dave Pitts' products are really solid and he provides really great support. Dave also upgrades the hardware year after year.


Reply
Share: