Laying out the cont...
 
Notifications
Clear all

Laying out the controllers

11 Posts
4 Users
0 Reactions
6,143 Views
Posts: 86
Topic starter
(@onceler)
Estimable Member
Joined: 9 years ago
[#47872]

I've been adding up the cost of my new found hobby and I'm afraid it is going to cost me an arm and a leg to get what I really want. Slightly more, if I go the watertight, "right way".

My first question I'm wrestling with is: my yard is split in two by the driveway. I am considering buying a smaller controller to handle the smaller side of the yard. And then on the larger side the new falcon controller to handle the bulk of my pixels.


10 Replies
Posts: 86
Topic starter
(@onceler)
Estimable Member
Joined: 9 years ago
onceler wrote: I am considering buying a smaller controller to handle the smaller side of the yard. And then on the larger side the new falcon controller to handle the bulk of my pixels.

I found this: "I personally believe smaller controllers that limit cable runs are better than a large controller with runs all over the place." which seems to parrot what I was thinking.


Reply
Posts: 631
(@stampedeboss)
Honorable Member
Joined: 13 years ago

Look at ESPixelSticks they are relatively inexpensive and depending on how far the out your props are spread out may be the most efficient use of funds. The more dispersed the more you don’t want a single controller. I have a dozen of them spread out in my display costing less than a larger board.

Sent from my iPhone using Tapatalk Pro


Reply
Posts: 172
(@rooster519)
Reputable Member
Joined: 11 years ago

I have the same issue you do, yard split by driveway. My first year I used 2 e682's in separate boxes connected by only 1 cat 5. It worked fine, no issues. In 2017, I rebuilt my setup and put both e682's in one box with multiple power supplies. I have very few elements on the small side of my yard and was able to accomplish the same outcome, but had to add a power supply to that side of the yard, and a couple of null pixels. I don't say all this to tell you which way is best, just that there are multiple ways to do things. Using PixelSticks are a great option, but still require power to the pixels, so you still get to run some wires, maybe not the 30' that I have, but some none the less. A lot will depend on the size of the elements you have on that side of the yard.

Just my 2 cents.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I have found that centralizing the controllers is a PITA. I have four F16s spread around the yard with just power and a cat5 going to them. I also have a window running on an ESP and a Ren64 up on the roof for the singing trees and a few props in the side yard. Did not like all of the wires coming to one location. bundle management became an issue.


Reply
Page 1 / 3
Share: