Centralized vs dist...
 
Notifications
Clear all

Centralized vs distributed

15 Posts
12 Users
0 Reactions
8,604 Views
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

More controllers spread around my show. Goal is to keep the data runs as short as possible. I also use remote FPPs to limit the traffic on the nets close to the controller.


Reply
Posts: 100
(@little-b)
Estimable Member
Joined: 9 years ago
jchuchla wrote:I always opt for more smaller controllers. That way when something fails, less of your show is affected.

+1 on this from experience. Plus I use my pixels around my eaves and some yard lights year round, so those controllers are more permanently mounted and wires are run to be hidden.


Reply
Posts: 447
Topic starter
(@glycerine)
Honorable Member
Joined: 7 years ago
Little_b wrote:+1 on this from experience. Plus I use my pixels around my eaves and some yard lights year round, so those controllers are more permanently mounted and wires are run to be hidden.

Ok. I also plan to have some permanently mounted, at least along the roof line where I cannot reach without a really tall ladder.


Reply
Posts: 319
(@dalep)
Reputable Member
Joined: 10 years ago

"Don't overlook the F4v3."

I keep looking at that controller, but in reality isn't it the same as using a differential receiver that's connected to a FV16 or F48? I mean you have to run a Cat 5 to it regardless if it's a controller or differential receiver, and they both run the same amount of pixels. The only advantage I see is it may keep running if other props go down?

My finger keeps hovering over the BUY IT NOW button, but a $20 distribution board will do the same task for me. Plus for just $75.00 more I can have another F16. Ahhh, too many decisions, lol


Reply
Posts: 447
Topic starter
(@glycerine)
Honorable Member
Joined: 7 years ago
DaleP wrote:"Don't overlook the F4v3."

I keep looking at that controller, but in reality isn't it the same as using a differential receiver that's connected to a FV16 or F48? I mean you have to run a Cat 5 to it regardless if it's a controller or differential receiver, and they both run the same amount of pixels. The only advantage I see is it may keep running if other props go down?

My finger keeps hovering over the BUY IT NOW button, but a $20 distribution board will do the same task for me. Plus for just $75.00 more I can have another F16. Ahhh, too many decisions, lol

Is the wifi module on the falcon controllers supported yet?


Reply
Page 3 / 3
Share: