Back for another tr...
 
Notifications
Clear all

Back for another try..

99 Posts
11 Users
0 Reactions
25.8 K Views
Posts: 527
(@dj-franqstar)
Honorable Member
Joined: 12 years ago
TazChaLet wrote:sounds like you were almost there with the arduino just didnt have the right connection too the computer too get it too work

:thup2:


Reply
Posts: 527
(@dj-franqstar)
Honorable Member
Joined: 12 years ago

you'll get it though...let us know what ur plans are


Reply
Posts: 44
Topic starter
(@bryanvandyke)
Eminent Member
Joined: 12 years ago

I never could find the right pin connection so I never tried it. I did buy it though
Can you send me your pin diagram for the connections. Thanks this might work after all.

Sent from my iPad using Tapatalk


Reply
Posts: 527
(@dj-franqstar)
Honorable Member
Joined: 12 years ago

Tx rx gnd thats it

Sent from my SM-G920V using Tapatalk


Reply
Posts: 527
(@dj-franqstar)
Honorable Member
Joined: 12 years ago

Or u need the pinout for the sockets?

Sent from my SM-G920V using Tapatalk


Reply
Posts: 44
Topic starter
(@bryanvandyke)
Eminent Member
Joined: 12 years ago

OK here we go ,, sorry about the delay in response ... crazy week at work.. just another quick question....
so as my picture shows above. I have sain smart 16 channel relay module and an Arduino Mega 2560. I picked up last year an FT232R Break out board at the end someone said I needed it but ran short on time to install it.
On the Break out board I will need to solder the wires for the TX RX and GND .. Do I need to connect the 3.3u to the MEGA board?
so when I get this accomplished and connected in the same fashion as dj connected to the Mega board, in Vixen what output do I use for the controller?
what code should I be using for the Arduino board to listen to the FT232R?
right now I am setting up for a basic 16 channels and I will later add the other board for 32 ( already bought it last year might as well use it for static displays when i go to renard next year)
You Guys and Gals are awesome. so Thanks in Advance for all your help!
Bryan


Reply
CatMan42
Posts: 363
(@catman42)
Reputable Member
Joined: 12 years ago

bryan, it all depends on the sketch that you're using. can you post the sketch you're using for the Arduino.

Mark


Reply
Posts: 527
(@dj-franqstar)
Honorable Member
Joined: 12 years ago

You connect it to the 5v not 3.3 make sure on the ft232 u have the 5v soldered

Sent from my SM-G920V using Tapatalk


Reply
Posts: 527
(@dj-franqstar)
Honorable Member
Joined: 12 years ago

Sorry to butt in mark lol

Sent from my SM-G920V using Tapatalk


Reply
CatMan42
Posts: 363
(@catman42)
Reputable Member
Joined: 12 years ago
dj.franqstar wrote:Sorry to butt in mark lol

Sent from my SM-G920V using Tapatalk

No Worries, we're all here for each other!!


Reply
Page 3 / 10
Share: