Actually, your SSR must NOT have the zero cross feature. If the SSR itself has the ZC feature then you can only trigger it near the ZC time, making it full on only. Controllers like the Renards have a ZC detection circuit so that they can send an ON signal to the SSR part way through the AC cycle. That is how they achieve dimming (later in the cycle means less energy means less light).
Correct.
I wasn't clear that you use the SSRs with controllers like the REN64, which need the SSRs, but the actual zero cross is in the REN controller.
MartinMueller2003 wrote:Actually, your SSR must NOT have the zero cross feature. If the SSR itself has the ZC feature then you can only trigger it near the ZC time, making it full on only. Controllers like the Renards have a ZC detection circuit so that they can send an ON signal to the SSR part way through the AC cycle. That is how they achieve dimming (later in the cycle means less energy means less light).
I'll take a stab at the technical, just for completeness. I'm sure the wiki has good detail if you need more info. The term "zero crossing" or zero-cross (sometimes ZC) has two meanings but both refer to the same event: the point where the continuously-changing AC voltage passes through zero on its way from positive to negative or negative to positive. The zero crossing is used both as a timing reference for dimming circuitry and as a safe time to switch certain loads on or off with minimal electrical noise.
A solid state relay (SSR) for dimming must be able to turn on at any point in the AC cycle so the load only receives a percentage of the current. An SSR with a ZC function includes additional circuitry that delays turning it on until the next zero-crossing event. This ensures pure on/off operation with loads that do not support dimming (cheaper fluorescent lights) or speed control (many motors.)
BF210 Is correct. If you were going to look for SSR's or boards that would allow dimming of AC Must be NON Zero Cross SSR's.
Mechanical Relays will not work at all for fading and contacts will wear quickly even in simple On/Off show applications.
I think what you will find "like I did" is your options are limited to:
1. build your own board with NON Zero Cross SSR's.
2. buy pre-made like the Renard Board
3. Change to DC powered lights "opens more possibilities for fading control"
4 Simply use the Relay board you found on Amazon as a simple On/Off show.
Good Luck.
