kychristmas wrote:I'm confused. Are you saying the DirkCheapies require more power?
Shouldn't. It's the same 680ohm resistor between the control side of the VO2223A chip and the PIC as you'd have with any other SSR.
What transformer were you using with the Ren64 to start with? If you have diagnostic LEDs on the 64 and the transformer was at 1A, the on-board LEDs could eat up a whole lot of that 1A when all channels are on, not leaving enough oomph for 64 external channels as well. I always used to run Ren64's with a 3A transformer.
I am saying that I could not get them to work when a regular A/C SSR would... It was not until I changed the way I power my boards and changed/put the transformer about 6 inches from it.. that they would function... even though a A/C SSR would function as should with my previous set-up.
Do I think they might require a bit more?. well maybe... but maybe they only are using what is required and the A/C SSR will still work with less??? and I happened to be giving the board less???
All I know is I put a different transformer next to the board... last year it was actually split with another board and worked fine. This year it needs it own to work the Dirks Cheap... had um... could just say lazy took over last year and it worked so why change it? Leave it to Dirk to keep me on my toes.
Yes.. they are the transformers that came with the ren64
All I'm saying is that when you hook up the DirkCheap and if it don't work... check board power first 🙂
I should note that my channel LEDS do not work on these board because of a change in parts.. that I did not do.. so I don't loose anything there
I did some more set-up/testing today and this is what I found.
Ren64 with 24 Channels of Regular A/C SSR's and I have 24 Channels of Dirks Cheap.
I found that in some songs the Dirks just weren't as bright as the lights with a/c ssr's... I then went into the test channel and went through that ren64 and started turning each channel on. I found that the more channels turned on, the channels on the Dirk's SSR's would dim. The more channels I turned on the more they would dim, until eventually you could barely see they were lit. This was very evident where I have candy canes on both sides of the walk. One side uses a A/C SSR and the other a DirkCheap. Some of Dirks SSR's would not even respond until I started from channel one and turned each channel off, they would become brighter. They reached full brightness at about 1/3 of my 48 channels.
I would think the only issue this may cause is if a sequence has alot of lights at any given time such as a finale... from my testing and my boards... these would be dimmer then the rest and if there were alot of channels on, this may affect the lights even turning on.
20 channels of Dirks have a hundred incan light strand to each channel, the 4 candy canes are less.
Interesting. I have 32 channels of candy canes off an SR32 to DirkCSSR and did not experience any dimming issues. I have noted that the DirkCSSR do turn on when vixen cell is at a 1 level - I kind of like that though.
