Purchasing Sequence...
 
Notifications
Clear all

Purchasing Sequences

36 Posts
7 Users
0 Reactions
6,864 Views
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
MartinMueller2003 wrote:
I have to ask the ibvious: Have you rebooted the computer since the USB came loose?

I tried everything for like 3 hours. Very strange for now I am gonna let it go. Gotta get my renard to communicate before I can even worry about sequencing. Working on that part today.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Sequencing and controllers are independent. I do my sequences in the spring when there are NO controllers connected.


Reply
Posts: 1065
Topic starter
(@olingerjccj)
Noble Member
Joined: 17 years ago
MartinMueller2003 wrote:
Sequencing and controllers are independent. I do my sequences in the spring when there are NO controllers connected.

I am not going to spend hours sequencing if I cannot get my laptop to communicate with the renard boards, but I agree sequencing should be done earlier in the year just decided late to do this.


Reply
Posts: 88
(@ptinhays)
Estimable Member
Joined: 18 years ago

What's up with your show PC? I own an IT company so I end up with PCs laying around collecting dust.
If you tell me what OS you prefer, I could get one up and running tomorrow and shipped out to you. It's late in the season so I'd hate to see someone struggling to essentially start over without at least a dedicated PC for the show.

I also have sequences going back 15 years that I can probably load onto it so you can pick and choose what you want. My show started with all incans using renard boards in 2010 and has slowly grown to more pixels than anything else. So there's a good mix of incan elements you can choose from in most of them. I still use my renards too. The PC wouldn't be anything special, but would get your up and running and probably last quite a few years for you.

About your drive from your show PC, kinda sounds like the partition table took some damage when the USB came loose. Pretty common issue with those types of adapters. What OS are you on? I may be able to provide you with some non-invasive processes to run on the drive that may be able to recover the partition table to get your data back.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

We have no idea what the real issue is. We have yet to see the patching screens. No one has seen a test sequence. The OP stated that he cut both ends of the cable, you only need to cut the end that connects to the USB adapter. Even if the patching is wrong, as long as the controller has more than 1 channel defined and is enabled, you should see the RX led light up.

Lights start with seeing the controller Config and a picture of the USB adapter with the wire attached. Then a picture of the other end of the cable and the jumper settings for the termination resistor.


Reply
Page 3 / 8
Share: