Nutcracker sequenci...
 
Notifications
Clear all

Nutcracker sequencing with an LOR controller

3 Posts
2 Users
0 Reactions
1,931 Views
Posts: 2
Topic starter
(@swamp-58)
New Member
Joined: 11 years ago
[#39548]

I am very new to this type of Christmas lighting. I am currently trying to create a sequence using an LOR controller along with and E682 controller for RGBs. When in the sequencing tab, what do I put in the sequencing segment to illuminate that channel. If I have more than 2 that are supposed to illuminate in the sequence, it only illuminates two. I only have 13 LOR channels. Do I use the DMX for the sequence effect or do I need to use something else.


2 Replies
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

are you using xlights? how is your LOR controller configured? are you using a DMX output from your E682 or are you using a USB LOR dongle? (or other?)
I am using an LOR USB dongle and I found out that it can work two ways in your setup screen--as a USB output (LOR) or a USB output (openDMX). The openDMX setting loses some of the LOR shimmer and similar effects, but I had throughput problems so I was not able to use the LOR dongle with the LOR protocol; the openDMX setup allowed my channels to be nice & "crisp"... I hope this helps


Reply
Posts: 2
Topic starter
(@swamp-58)
New Member
Joined: 11 years ago

Yes I am using xlights. For the e682 I am using E1.31. I will change the dongle and see if that helps


Reply
Share: