PVC Bendit tool
 
Notifications
Clear all

PVC Bendit tool

23 Posts
14 Users
0 Reactions
39.7 K Views
Posts: 122
Topic starter
(@schuricg)
Estimable Member
Joined: 11 years ago
[#49227]

Anyone in the Houston area with a pvc bendit heating tool available to rent or borrow? Looking to add a 360 tree and want to bend a 2 inch pvc pipe to make the 6 or 8 foot base circle

Sent from my iPhone using Tapatalk Pro


22 Replies
JCook
Posts: 1003
(@jcook)
Noble Member
Joined: 13 years ago

If you can't find one of them, you can use the hot sand method. I bent 1" pvc with this method 180 for my doorway arch. You can bend the pvc like a wet spaghetti noodle. Its not that hard.

Here are some basic steps to get you started.

Using play sand.
-cap one end of the pvc
-pour sand into the pvc to measure out the right amount of sand.
-pour sand plus a little extra into an old pot/pan and heat on your grill outside. It doesn't have to get too hot.
-using a metal funnel, pour heated sand into pvc.
-let it "bake" for a few minutes
-bend into your desired shape.

This arch was made using hot sand.

2015 09 26 17.18.47a

Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

I recently made myself a homemade pvc bendit. I used nichrome heating element wired found on eBay for very cheap. I took a 24’ length and folded it in half twice and pulled it into 3/8” metal flex tubing. To do larger sized pipe, i just sleeve multiple bigger sized metal flex over the smaller one until it’s close to the right size. The biggest I’ve bent was 1.75” ID and it went pretty smoothly. Since all of the metal flex was just scrap pieces I had laying around, all it cost me was the $6 or so for the nichrome heating wire.

Sent from my iPhone using Tapatalk


Reply
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago

Why do you want to bend 2" PVC? My first 6 years I had some gray 3/4" conduit for a tree base (I now use 3/4" EMT). The conduit bends in an 8' circle rather easily. I've bent 1" PVC using the method above, and I wish I had had a jig to follow.


Reply
aknflyer
Posts: 371
(@aknflyer)
Reputable Member
Joined: 10 years ago

Or alternatively, check with the local phone company or the contractors who run cable. I got a used 6' cable reel that produced 2ea 6' steel square tube rings, just by asking at a local construction site. They also come in 8' sizes.


Reply
Page 1 / 5
Share: