North Pole Mounting...
 
Notifications
Clear all

North Pole Mounting?

18 Posts
7 Users
0 Reactions
8,433 Views
Wolfie
Posts: 2225
Topic starter
(@wolfie)
Noble Member
Joined: 11 years ago

No rush, not likely I will get them out this year. If I do, I do, if not, well, summer project.


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

4" toilet flange works. Just run 2 stakes through the flange holes.

31uzXIax2fL. SX300

Reply
Aurbo99
Posts: 2804
(@aurbo99)
Famed Member
Joined: 19 years ago

I use a 4" pvc pipe for my NorthPole

I use a 6 foot length of 3/4" rebar strapped to a 3 foot 2x4 that was trimmed to fit snug inside.

Tap the rebar down 3 feet into the ground and square it up, slide the north pole over it.


Reply
Posts: 191
(@mlevings)
Estimable Member
Joined: 14 years ago

I purchased all of my globes from here: http://www.superiorlighting.com/8_Inch_Plastic_Globe_Plain_Lip_Opening_White_Acryl_p/02024wa-08wl.htm
The 3d print files should be attached below.


Reply
Pwmcguire
Posts: 575
(@pwmcguire)
Honorable Member
Joined: 18 years ago
Aurbo99 wrote:I use a 4" pvc pipe for my NorthPole

I use a 6 foot length of 3/4" rebar strapped to a 3 foot 2x4 that was trimmed to fit snug inside.

Tap the rebar down 3 feet into the ground and square it up, slide the north pole over it.

In the rebar section get a 3 ft or 4 ft concrete form stake with holes in it. Then you can run a couple of screws through it to hold a 2x4 then slip the pvc over it. Then run a couple of screws through the outside of the pvc in to the 2x4


Reply
Page 2 / 4
Share: