PropController daug...
 
Notifications
Clear all

PropController daughterboard extender

10 Posts
3 Users
0 Reactions
6,318 Views
Posts: 789
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

What about using 2x rs485 lines and transporting all of the pins?


Reply
budude
Posts: 10400
Topic starter
(@budude)
Illustrious Member
Joined: 18 years ago
chilloutdocdoc wrote:What about using 2x rs485 lines and transporting all of the pins?

Hmm... Personally, I'd rather stick with a single wire - if we need four lines it might be better to use RS-232. I know it will limit the distance and require a different board but I think the benefits would outweigh the requirements of always having to have two cables. Which boards require 4 wires at this point? I know for the LSD port that I only need three - the 32-channel dimmer has all four but - and I'm not sure how/why it's used - but the fourth wire goes to the SSR outputs?


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
budude wrote:the 32-channel dimmer has all four but - and I'm not sure how/why it's used - but the fourth wire goes to the SSR outputs?

I know why, and I guess I should tell people this, the fourth I/O is for a 1-wire temperature sensor.


Reply
Posts: 789
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

True, if you really need more wires I guess you could use a bcd decoder or a shift register, would slow down the.data, but more pins for less wires.


Reply
budude
Posts: 10400
Topic starter
(@budude)
Illustrious Member
Joined: 18 years ago

Well... I'm open to suggestions regarding which chip(s) to use for this. Maxim has a quad driver chip but it operates at 3.3v. This is fine for the Prop side but I am planning to transport 5v, not 3.3v to the far end so this would not work. The 3.3/5v-either versions are wicked expensive - like $10-12 PER chip - way too much... I didn't really want to do an SMD version to make it simpler to make (ideally single-sided home-etch if possible). I was also hoping to make the two ends the same as well to save some confusion.

I think the 65LBC179 might work using 5v supply on both sides and it seems like it would support 3.3 or 5v logic? I realize it would take 3 of the chips at each end but the chips are easy to find.


Reply
Page 2 / 2
Share: