PropController daug...
 
Notifications
Clear all

PropController daughterboard extender

10 Posts
3 Users
0 Reactions
6,317 Views
budude
Posts: 10400
Topic starter
(@budude)
Illustrious Member
Joined: 18 years ago
[#15307]

One thing I think this project may need at some point is a daughterboard extender that will allow you to place the daughterboards at a significant distance from the PropController main board. Greg has this capability on his Helix and it's a great idea. My thought is that it would have the 8-pin SIL connector at one end and an RJ-45 at the other. We could transport 3-signals over 3 pairs and supply power over the other pair. Of course, you would need a set of two for each daughterboard.

I'll look into drawing something up for this.


9 Replies
Posts: 789
(@chilloutdocdoc)
Prominent Member
Joined: 18 years ago

Was the data sent via a RS485 interface or something? This would totally alleviate about half of my controllers in the show if I could do this.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
budude wrote:My thought is that it would have the 8-pin SIL connector at one end and an RJ-45 at the other. We could transport 3-signals over 3 pairs and supply power over the other pair.

Greg's transports 3 I/O pins if memory serves, are you thinking 3 or 4?


Reply
budude
Posts: 10400
Topic starter
(@budude)
Illustrious Member
Joined: 18 years ago
DynamoBen wrote:Greg's transports 3 I/O pins if memory serves, are you thinking 3 or 4?

It would have to be limited to 3 pins because the extender power has to be supplied via the RJ45 as well. I think this will be OK for most boards. I was thinking of RS-485 but I suppose it could be RS-232 if you wanted more I/O pins transported.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
budude wrote:It would have to be limited to 3 pins because the extender power has to be supplied via the RJ45 as well. I think this will be OK for most boards. I was thinking of RS-485 but I suppose it could be RS-232 if you wanted more I/O pins transported.

I knew at some point I would pay for adding that extra pin to each header. 😉


Reply
Page 1 / 2
Share: