Hey guys,
So in the final stages of getting my display up (hopefully no later than this weekend!) had a final question on power injecting. I am running 5v 50 pixel strings (3 inch spacing) running about 40-50% brightness. I was testing them all last night and of course when on 100% white having some voltage drop after 1 string. However I noticed that my normal display patterns and sequences are not lagging and colors look to be fine up to 200 pixels which is the max length I have for any one run. Is there any danger of physical damage to anything if I don't power inject or is it more that my display may just not light correctly? I plan to do a final test with everything in place but thought I would get everyone's input here as well.
If it ain’t broke don’t fix it. The only concern would be is how close are you coming to the max out out of your power supplies. Even at 40%~50% you could easily go down to 30% with out noticing the difference to save a little more power
Sent from my iPhone using Tapatalk
TSL wrote:If it ain’t broke don’t fix it. The only concern would be is how close are you coming to the max out out of your power supplies. Even at 40%~50% you could easily go down to 30% with out noticing the difference to save a little more powerSent from my iPhone using Tapatalk
Turning brightness down is more pleasing for the viewers. At 100% the colors all blend together and look like a big bloob. This is really noticeable in pixel trees. My first 2 years I ran my trees at 100%. You really could see the individual colors and the brightness was overwhelming. Then I turned it down to 25%. Way, way better on the viewers eyes and you could actually distinguish the individual colors. The other bonus is you can run more pixels without injection.
Sent from my SM-T710 using Tapatalk
For me, controlling brightness is an attempt at balancing the brightness of the individual props to make the show more pleasing (no hot spots etc.). For example, the candy canes with exposed front facing pixels run at 40%. The arches right next to them with pixels embedded in a pex tube run at 100% and both have about the same visual impact on the viewer. My 33mmx33mm pixel grid runs at 50% due to the high density of light (works like a searchlight if it is at 100%). As for damaging things because you are undervoltage: Nope no issue here. You wont break anything. You might get some unexpected flickering here or there, a bit of pinking when you expect white but other than that you should be ok.
