another solution to...
 
Notifications
Clear all

another solution to flicker

5 Posts
3 Users
0 Reactions
2,260 Views
Posts: 135
Topic starter
(@ptone)
Estimable Member
Joined: 16 years ago
[#12994]

I had bought a number of LED types to see how they dimmed. Many in initial tests dimmed poorly.

Most full wave ones had little to no low end - going from off to pretty bright.

Other lights flickered as they dimmed.

However if I ran the dim at a much faster DMX rate, say 100hz, then the flicker goes away.

Still trying to sort through it all.

-Preston


4 Replies
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago
ptone wrote:However if I ran the dim at a much faster DMX rate, say 100hz, then the flicker goes away.

I don't understand what that means. How can you dim at a faster rate than the line frequency.:confused:


Reply
Posts: 87
(@brianmiller)
Estimable Member
Joined: 17 years ago
ErnieHorning wrote:I don't understand what that means. How can you dim at a faster rate than the line frequency.:confused:

This would depend if the output voltage is DC. If it's DC... it's easily accomplished. What controller?


Reply
Posts: 135
Topic starter
(@ptone)
Estimable Member
Joined: 16 years ago
ErnieHorning wrote:I don't understand what that means. How can you dim at a faster rate than the line frequency.:confused:

Well in the case where I'm doing greater than line frequency - I'm sending DMX to DMX fixtures - so it is about driving their own microchip controllers. These are commercial LED par cans.

-Preston


Reply
Posts: 87
(@brianmiller)
Estimable Member
Joined: 17 years ago

Sounds like PWM to me.


Reply
Share: