xlights to e6804 ou...
 
Notifications
Clear all

xlights to e6804 outputs

15 Posts
4 Users
0 Reactions
3,470 Views
Posts: 10
Topic starter
(@richerich)
Active Member
Joined: 11 years ago
[#39402]

This is my first year doing pixels. i have the eaves of my house coming from output 1 on the e6804 and i have some snowflakes on output 2. can someone please tell me what channels the snowflakes should be on?

current set up:
Eaves-145 pixels
2 snowflakes- 48 pixels each

see photo for xlights configuration. i chose output 2 in lights for the snowflakes starting at channel 1. but they display the same as output 1.

layout1

14 Replies
Posts: 191
(@mlevings)
Estimable Member
Joined: 14 years ago

It looks to me like they should start on 436 and 580. Make sure you have the controller setup in xlights on the networks tab with the universes that you are using on it. You don't specify the output on the model preferences, only the actual start channel.


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago
Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Just by running what you have so far
Output 1-Xlights channels 1-435 Output 1-1 e6804 Universe 1 start and end 1-435
Output 2-Xlights Channels 436-723 Output 1-2 e6804-Start 1 Universe ch436 end universe 2 ch 213


Reply
Posts: 10
Topic starter
(@richerich)
Active Member
Joined: 11 years ago

Thanks for the quick answers. i dont have my controller with me right now. does the controller automaticallly determine the output?

for instance on the 6804 setup. i have output 1 set to 145 2811's, and output 2 set to 96 2811's. does it know that channel 436 of universe 1 is the first pixel on output 2?


Reply
Posts: 10
Topic starter
(@richerich)
Active Member
Joined: 11 years ago

i dont think that spreadsheet worked for me. it gave me a huge number of channels. if i test it with a string length of 5 it says thats 60 channels. dont know about that.


Reply
Posts: 10
Topic starter
(@richerich)
Active Member
Joined: 11 years ago

i think i found my problem. i need to set my start address for output 2 on my controller set up page.


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Hold please...
Your first output would be 145 pixels which is 435 channels, So you first universe would be made up of 1-435 of the first string and your second output (two snowflakes) would then pick up still in universe 1 at 436 and then spill over to universe 2 at 213. (you set your 6804 that way)

Just remember xlights channels aren't the same. They continue 1-435 436-723 and so on. That excel sheet will make sense once you see it.


Reply
Posts: 10
Topic starter
(@richerich)
Active Member
Joined: 11 years ago

I believe i understand now. and that spreadsheet could be helpful. but i think it has a glitch.

creates way too many channels for me

glitch

Reply
Posts: 376
(@k-state-fan)
Reputable Member
Joined: 16 years ago
richErich wrote:I believe i understand now. and that spreadsheet could be helpful. but i think it has a glitch.

creates way too many channels for me

It is assuming you are using all four outputs on each output group that the 682 has.


Reply
Page 1 / 2
Share: