xLights Test Setup
 
Notifications
Clear all

xLights Test Setup

9 Posts
4 Users
0 Reactions
3,057 Views
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

Replied to you on PM. Recommend downloading SACNview & using it to help you troubleshoot your universes. It is a VERY handy troubleshooting tool for e1.31 streams. A few questions about the E682 browser, too--you should post a screen shot of your browser config and perhaps someone will see something obvious there...


Reply
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago

Got PM - thanks - will check more out tomorrow morning.


Reply
Posts: 210
(@gadgetsmith)
Estimable Member
Joined: 13 years ago
covewi wrote:
I am running a MAC and have the e682 connected using a CAT 5 cable. Shouldn't be any problems with that.

Not familiar with MAC, but if a Windows PC is disconnected from a router, it's IP changes.

I'd suggest verifying the IP of your MAC is on the same network as your E682. Better yet would be to connect the 682 to your network router/switch.


Reply
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago

Its a great day!

I am really a MAC guy but today I have switched over to the PC side. The Matrix would have been up and running on Monday if not for my MAC obsession.
It appears a MAC cannot communicate with the e682 directly. I can log in to the config page and make setting changes. But when the I connect the e682 directly to my MacBook nothing communicates or works.

I brought out an old Dell Inspiron 6000 - hooked the board up an WOW - lights control on my first 50 pixel string.

I would really like / need to use lights with my MacBook for commuting power.

Has anyone run across this problem before and is there a fix?

Thanks to so many for your help. I might actually be able to celebrate with matrix fireworks this New Years Eve.


Reply
Page 2 / 2
Share: