xLights Test Setup
 
Notifications
Clear all

xLights Test Setup

9 Posts
4 Users
0 Reactions
3,058 Views
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago
[#40179]

Thanks to everyone I got connected to the e682 config page.
I need to test that a 50 pixel string is working and connected properly to xLights.

I would like to run a "test lights" in xLights. Properly connected a pixel string to group 1 J1 on the e62.
Then set this up.

Screen Shot 2015 12 25 at 9.01.00 PM

Screen Shot 2015 12 25 at 9.01.12 PM

Test Page

Screen Shot 2015 12 25 at 9.02.35 PM

Nothing happens when turning on "background only / intensity"

Any suggestions?

Covewi


8 Replies
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

on the test page does it say anything in the bottom left corner like output too lights isnt checked??


Reply
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago

Yes - checked.

Screen Shot 2015 12 25 at 10.36.33 PM

Setting the config page to multicast, group 1 50 pixels and no test pattern should be correct.
This was set up on a hard wired PC.

I am running a MAC and have the e682 connected using a CAT 5 cable. Shouldn't be any problems with that.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

what version of xlights are you running and you setup the 682 page not seeing your setup for that


Reply
Posts: 793
Topic starter
(@covewi)
Noble Member
Joined: 17 years ago

3.6.10 Runs well no the MAC. Later versions seemed to have some problem.
Just started up 4.2.25 and no bugs. But no lights output to lights.


Reply
Page 1 / 2
Share: