Thanks guys, I get that bit, but does it matter that I would end up with two resistors in series if I linked the boards, which I intend to do? The last board wouldn't be a problem as that would be the termination source, but if I went out of the board through a resistor and into the next board through a resistor, I'd be passing through two in series. Would I simply jumper the one or let it pass through the two? Sorry if I'm being daft!
Edit. Just looked at your lights timon! Very nice! I can see you've added the footprint for both resistors. Will these be installed or will you jumper the one to avoid having two in series?
There should not be any problem with having two 33 Ohm resistors in series. I'd start worrying (or using a scope to verify waveforms) when the sum of the resistances exceeds perhaps 500 Ohms or 1000 Ohms (assuming perhaps 200ns waveform features and perhaps 50pf of total capacitance).
Plus 33 ohms is a starting point. I've seen several with 75 ohm resistors. Basically your over thinking the problem, just install the resistors and start with the default values. BTW, the output on the end is just left open, no termination is needed.
Thanks guys! I understand better now! I don't like doing things if I don't understand them :blush: I'll post up how it goes :thup:
