Hi Guys,
Long time lurker, just recently registered as I thought I'd throw a few projects together for Christmas 2013. The projects on here are awe inspiring! Haven't seen many full on displays over here in the UK so I thought I'd start a trend in my area :happy: I've picked up loads of information just reading the forum the last few months, so thank you for sharing your ideas and creations and hopefully I can share a few of mine soon :happy:
I've started collecting bits for the Finally Affordable Snow Tubes and I thought I'd make a few with pixels for some extra control. I'm not adept with software and hardware control (still learning) but I can use Eagle quite well for PCB's, understand schematics and build PCB's etc... I have a load of WS2811 IC's and some RGB 5050's and have laid them out in eagle to create strips similar to the FAST's. According to the data sheet a 33ohm resistor is recommended on the data input or output of the WS2811. Would I need one on each of the IC's I put in the strip, or one at the beginning of the strip? I'm reading it as one on each WS2811, but would like to check as a duff batch of PCB's still costs :blush2:
Many Thanks
The data sheet recommends resistors both on the input and the output. The reason given is for protection of the input/output pins. Normally, in the integrated circuit, there are diodes to VCC and ground. A resistor in series with the input will limit the maximum current that will be seen by the diodes. Normally, I would just recommend the source termination on the output pin.
So, if you are doing a custom board, you need only place the resistors on the board where signals come in and go out of the board. The items within the board will not need the protection.
Many thanks for the reply. Is the output resistor really necessary? There is no return data required to the controller and if multiple boards were linked there would still be the input resistor on the next board. If I had a resistor on the output as well I would end up with two 33ohm resistors in series for every board added. It would output the one board through the resistor, but then go into the next board through another resistor.
There are two common purposes for an output resistor - to provide a source termination for a high-speed signal and to protect the output of the IC in case of a short to ground/power. I'd put it in if I were you, if for no other reason than as a knob to tweak if you have problems sending data to a second string or board. You are going to a lot of trouble here (over just buying pre-assembled from China), so one more resistor isn't going to hurt much.
I've as this question about another part like the WS2811 and the response has always been "If it leaves the box, strip or what ever and enters another one then use the resistor. Bottom like is that is's only a very cheap resister so why not protect your self. The Flower Pixel Path Lights that I hope to be selling soon has them just so I don't have to worry about the chip getting blown out.
