Wire for Custom Pro...
 
Notifications
Clear all

Wire for Custom Props with Pixels

8 Posts
6 Users
0 Reactions
1,942 Views
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago
[#56939]

I'm 3D printing some custom oversized bulbs that will light up with 2811 pixels. What bulk wire would you recommend to connect the props?


7 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

That all depends on the number of pixels, the voltage level, and the distance between each. (Don't forget the distance from the controller.)


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago
MichiganLights wrote:I'm 3D printing some custom oversized bulbs that will light up with 2811 pixels. What bulk wire would you recommend to connect the props?

I use 4 conductor Monoprice speaker wire. It is available in a variety of AWG to suit your needs. If I only need 3 conductors I can usually pull the 4th conductor out of the jacket if it is not too long of a run and save that length of wire to use elsewhere. I will also use the 4 conductor wire to do 2 Power Injection runs from one cable.


Reply
MichiganLights
Posts: 479
Topic starter
(@michiganlights)
Prominent Member
Joined: 14 years ago

The current, power and voltage drop I can figure out. :unsure:

I wasn't sure if a twisted pair or shielded cable is required because of the data line.

How about connectors. What is typically used that is inexpensive?


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

I use stranded Cat5 or Cat6. It will cary data further than just about any other type of wire. Solid colors are twisted together for ground, Orange/White is data, and the rest of the color/stripes are Positive. I have runs over 30' with no issues.


Reply
Page 1 / 2
Share: