Why does E682 want ...
 
Notifications
Clear all

Why does E682 want earth ground reference?

25 Posts
13 Users
0 Reactions
8,474 Views
Posts: 1159
Topic starter
(@deonb)
Noble Member
Joined: 13 years ago
[#34652]

One can spend a lifetime just studying ground wiring...

I just saw this in the E682 manual for the first time:

"As a safety measure, the negative side of the power supply should be connected to earth ground by wiring a jumper between the power supply’s GROUND terminal and the V- terminal."

Why would you purposefully ground-reference the negative output of an isolation transformer? (i.e. what makes it safer? Floating actually seems safer in this case).


24 Replies
duramadmax
Posts: 904
(@duramadmax)
Noble Member
Joined: 16 years ago

i did mine this way and so far no troubles. I guess if you get maybe a electrical charge of your display (high amperage due to dc voltage i assume ), the reference has a straight shot to ground. Other than that I dunno


Reply
intwoit2002
Posts: 412
(@intwoit2002)
Honorable Member
Joined: 18 years ago

I think it says "should". Makes sense from a shock point of view, working in the yard with no ground ref. on output of power supply it is possible for the pixels to float up to a higher potential and cause a hazard. This assumes you are using a grounded AC cord. First year found out how much potential can show up from leaky power supplies. All mine are grounded.


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

How exactly do you wire the ground on an e682 to a power supply?


Reply
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

Tucsonlights--I installed a physical jumper wired between the "V+" of my 5V PSU to the 120VAC ground terminal of my PSU. I used this setup last year and it worked well and I am using it again this year. No problems.


Reply
Page 1 / 5
Share: