Thanks for the review. Does the controller support the virtual string concept on the outputs?
MartinMueller2003 wrote:Thanks for the review. Does the controller support the virtual string concept on the outputs?
Not certain if it does/doesn't. You might be able to reach out to them directly with that. Like I was saying above, there is a whole lot of things currently encompassed in the config file, but do not present in the GUI.
-Tony
MartinMueller2003 wrote:Thanks for the review. Does the controller support the virtual string concept on the outputs?
Simple answer Yes.
The day I got the second Experience light board in, I got hit with the flu which put me in bed for a couple of days and finally got around to do a little testing using the 4 Output Long Range Pixel Genius Receiver and toying with virtual strings.
The 4 Output Long Range Pixel Genius Receiver is slightly larger than other receivers I have used. It still fits nicely in a TA-200, consuming about 90-95% of the space. One note, the screw holes do not align with the mounts in the TA-200, so if you use one, you must drill hole to properly secure the receiver.
I opted to use a CG-500 and mounted it with a Model S-60-12 power supply (12V 5A) I got online. As is the case with the TA-200, the mounting holes do not align with the mounts in the CG-500.
In my opinion, the power LED is blindingly bright. Brightness can be reduced by 75% and it would still be effective. The board also has a heartbeat light, which flashes when attached to the controller board.
The spring-loaded terminals seem to work pretty well. The wire seats deep enough that you do not have to worry about a stray cable strand. Combine that with polyfuses and on board test modes. Both the 8-bit shift register (SN74ACHT594N) and the array resistor (B 330G) are socketed for easy replacement.
One last item to note, this board seems to give off more heat than other receiver boards I have used. Although not shown on the website, U5 and U6 are covered by a seven-finned heatsink to dissipate the heat. Although the sink does not get hot enough to burn, it does get uncomfortable to the touch after about ten seconds. I don?t see this being a problem in my area of the country, but it is something to consider if keeping controllers cool is a challenge in your area of the country.
I was able to set up virtual strings without issue. The process is as simple as a mouse click, then identifying the channels you want to use.
