I just purchased an F16v3 that showed up in the mail with the SD card slot damaged. So this board will be stuck on version 2.0.
Can anyone compare the two, what will the board be limited to on version 2.0 or/and what problems will it have with that software?
Trying to decide if the board is going to be usable or not.
I would check out this link which is titled "F16V3, F48 and F4V3 Firmware Release Notes". I think that would best answer your questions as it contains the information for the various firmware revisions after 2.0. Then you can decide what you want to do.
https://docs.google.com/document/d/1xcEewFtAJ8EzxstdH9H6LRlWAlYiTKY2z8ymwAUN_-Q/edit
Thanks HockyHunter for the link.
MikeKrebs,
I am weighing in on repairing it also, I haven't found the same type of sd slot yet. Have an idea what part number it would be to search?
@MikeKrebs I should of posted an update yesterday. I sent an email to David Pitts the other day and got a reply super fast, hes great. He sent the part number from mouser and they are already on the way.
The board was bought as a backup so if somthing happend I wouldn't be SOL. The version isn't going to effect its use but I will try to repair it. Bought 5 sockets, I know im going to mess the first one up.
I'd worry more about messing up the board than the socket. Be careful on how much heat you use, and solderwick will be your friend. Use some very small solderwick. Actually...what I do when removing a part thats bad, I use a razor blade to cut the pins (if accessible) and then solderwick the remains away. Good luck!!

