Waterproofing Pixel...
 
Notifications
Clear all

Waterproofing Pixel Splices

20 Posts
13 Users
0 Reactions
3,480 Views
Posts: 15
Topic starter
(@jaronervin)
Eminent Member
Joined: 12 years ago
[#54749]

Hello!

I live in the Northeast US, where winters can be rainy, snowy, or dry… or some combination of the 3. I have become acclimated to creating waterproof AC wires with vampire plugs. However, I’m not sure how to create a guaranteed waterproof splice for pixels, whether it is replacing bad pixels, wiring pigtail connectors, or just extending the distance from the string to the controller.

How does everyone handle waterproofing pixel strings? Do you solder and heatshrink? Is there a specific connector available for such a small gauge of wire? Is there some other method that I haven’t found yet?

Thanks!
Jay


19 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

We use glue lined shrink tube when making a splice.


Reply
DrNeutron
Posts: 2018
(@drneutron)
Noble Member
Joined: 14 years ago

Well I live in Nova Scotia on an island that juts out into the Atlantic so I do things a bit "over the top" perhaps....
For each conductor, I solder and use adhesive lined heatshrink and then I cover all conductors in another larger piece of heatshrink that covers the insulating sleeve.
Always use pure copper and never use CCA wire! I made that mistake and most of my connections for stars were useless after 3 or 4 seasons.
I also use a dab of dielectric grease on all my pixel connectors and gaskets. It's the little things that make the greatest impact....


Reply
Posts: 344
 TSL
(@tsl)
Reputable Member
Joined: 10 years ago

I use liquid electrical tape. No issues with it. Other than keeping the spices apart till it drys.

Sent from my iPhone using Tapatalk


Reply
TomL8345
Posts: 1356
(@toml8345)
Noble Member
Joined: 15 years ago

When I am building props and working on strings in my basement, I will solder, heat shrink (with 3:1 adhesive lined) and then put a larger piece of similar heat shrink over the smaller heat shrink connections. If I am doing a field repair I will use the heat shrink solder tubes.


Reply
Posts: 41
(@mickisdaddy)
Trusted Member
Joined: 5 years ago

If I am connecting two 50 node pixel strings would it be waterproof enough for me to just use the connectors that come on the strings and then use the glue lined hear shrink over the whole connector?


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Post picture of connector


Reply
Posts: 41
(@mickisdaddy)
Trusted Member
Joined: 5 years ago
crop

Here is the connector.


Reply
Posts: 41
(@mickisdaddy)
Trusted Member
Joined: 5 years ago

I live in southwestern Arizona. We don't get very much rain at all.


Reply
joeytx
Posts: 249
(@joeytx)
Reputable Member
Joined: 19 years ago

While I don't live in an extremely wet climate, sometimes we do get quite a bit of rain during the winter. I use the same JST connectors pictured for 90% of my pixels. I dip both the male and female JST connector in CorrosionX before putting them together. I have never had a data issue.

CorrosionX

Reply
Page 1 / 2
Share: