4586shaggy wrote:Your want to keep the ps lower than 80% efficiency on a generic ps, and around 95% on a mean well. That means if you have a generic that is rated at 300W/60A, you want to keep the total draw at or lower than 240W/48A, and 285W/57A on a mean well. That's best practice for the lifespan of any ps. Don't crank the resistor based pixels up too far, 12.15v is about as high as they like to go... Any higher and yes you will prolly burn them out quicker (relatively speaking). But regulators are able to take the higher voltage and only use what it needs, hence the longer lifespans and better color consistency throughout the strand, vs resistor that takes what's coming in and drops it down a set voltage regardless of the input voltage.Sent from my Pixel 2 XL using Tapatalk
Ahhh....12.15v....would be the magic upper number....I'm thinking, since I'm dealing with some voltage drop, that I need to focus on voltage at the pixel instead of at the PS itself.....
As far as efficiency that's current ratings.... But I always try to leave some 'headroom' for the PS in case of spikes in current....and I never push the rated limit to the edge....I learned THAT lesson long ago....
Also.....how do you know if it's a resistor or regulated pixel? These are Ray's WS2811's....and I suspect they're of the regulated variety but I don't know that for sure....
Take a picture of both sides of the pixel and post it.
Sent from my Pixel 2 XL using Tapatalk
Those are regulated
Sent from my Pixel 2 XL using Tapatalk
4586shaggy wrote:Those are regulatedSent from my Pixel 2 XL using Tapatalk
Thanks...so what's the giveaway?


