Hey All,,
I'm about to do some power injection on a pixel prop that doesn't have a power supply close by....
I realize with distance comes a corresponding voltage drop and that a 12 volt pixel will operate on slightly less than 12 vdc.
Does anyone know what a minimum voltage is needed for 12 volt pixels...?
Thanks
Depends if they are regulated or resistor based. Resistors actually like it slightly less than 12v, where regulated pixels can run anywhere from 11.5-14v stable.
Sent from my Pixel 2 XL using Tapatalk
4586shaggy wrote:Depends if they are regulated or resistor based. Resistors actually like it slightly less than 12v, where regulated pixels can run anywhere from 11.5-14v stable.Sent from my Pixel 2 XL using Tapatalk
Thanks for the response.... I would have figured +/- 10% from the 12vdc....but it looks like it's more like 5% on the low end and 16% or a little more on the high side...interesting that the 20% variance between low and high is skewed toward the high side. I might have to crank up the output voltage on the Meanwell a bit....wonder how much I can adjust it up.....I'm guessing running at the max will shorten the life of the PS....
Your want to keep the ps lower than 80% efficiency on a generic ps, and around 95% on a mean well. That means if you have a generic that is rated at 300W/60A, you want to keep the total draw at or lower than 240W/48A, and 285W/57A on a mean well. That's best practice for the lifespan of any ps. Don't crank the resistor based pixels up too far, 12.15v is about as high as they like to go... Any higher and yes you will prolly burn them out quicker (relatively speaking). But regulators are able to take the higher voltage and only use what it needs, hence the longer lifespans and better color consistency throughout the strand, vs resistor that takes what's coming in and drops it down a set voltage regardless of the input voltage.
Sent from my Pixel 2 XL using Tapatalk
4586shaggy wrote:Your want to keep the ps lower than 80% efficiency on a generic ps, and around 95% on a mean well. That means if you have a generic that is rated at 300W/60A, you want to keep the total draw at or lower than 240W/48A, and 285W/57A on a mean well. That's best practice for the lifespan of any ps. Don't crank the resistor based pixels up too far, 12.15v is about as high as they like to go... Any higher and yes you will prolly burn them out quicker (relatively speaking). But regulators are able to take the higher voltage and only use what it needs, hence the longer lifespans and better color consistency throughout the strand, vs resistor that takes what's coming in and drops it down a set voltage regardless of the input voltage.Sent from my Pixel 2 XL using Tapatalk
Just clarifying the verbiage for someone reading this way down the road, you mean lower than 80% //capacity//, not efficiency. You want the most efficient ps you can find [emoji6].
The argument is 100% spot on though!
Sent from my SM-G955U using Tapatalk
