Using a raspberry p...
 
Notifications
Clear all

Using a raspberry pi2 directly control led strips help needed

3 Posts
3 Users
0 Reactions
1,644 Views
Posts: 792
Topic starter
(@boarder3)
Noble Member
Joined: 19 years ago
[#44745]

i want a raspberry pi2 directly to control led strips is there a product i could buy i dont really want to make something myself. just want it to be as small as possible to switch light colors every 5 minutes for under bar and light cove. Any other ideas would be great to beside rasp pi


2 Replies
Posts: 138
(@brettjm)
Estimable Member
Joined: 13 years ago

If the strips are ws2811 pixel you could us the Falcon PiCap. It has 2 outputs that can control 800 pixels each.
https://www.pixelcontroller.com/store/index.php?id_product=47&controller=product


Reply
Posts: 2168
(@djulien)
Noble Member
Joined: 19 years ago
boarder3 wrote:i want a raspberry pi2 directly to control led strips is there a product i could buy i dont really want to make something myself. just want it to be as small as possible to switch light colors every 5 minutes for under bar and light cove. Any other ideas would be great to beside rasp pi

It depends on what is meant by "make something myself". It is possible to run WS281X LED strips directly from a RPi without an additional controller, but you need special software to do it. If you are comfortable with using custom or open source software and can solder the connections on the LED strip safely, then there are at least 2 ways using the GPIO pins (SPI or GPU).

If the LED strip is close to the RPi, you can connect the data signal directly. If the LED strip is a few feet or more away, you will probably need to use either a voltage level shifter or run the LED strip at lower voltage (3.5 - 4.5 V). This is because the RPi GPIO pins are only 3.3V which is very marginal for the 5V data signal needed by the WS281X LEDs. (I haven't tried it with 12V LED strip, so I'm not sure if you'd need the level shifter)

NOTE: if you have more than about 15 or so LEDs, don't power the LED strip from the RPi - use a separate power supply directly to the LED strip, with a common ground to the RPi.

BTW, you don't even need a RPi to do this. The smallest possible approach would be an 8-pin PIC or AVR and a capacitor (about $1 of parts and the size of a US coin), but that approach would require familiarity with programming either of those micro-controllers.

My apologies if the above is cryptic info. I wasn't sure what your background knowledge was so I didn't include much detail. Please feel free to ask additional questions - there are many helpful people here and a lot of info shared on this forum.

don


Reply
Share: