Notifications
Clear all

Using 2 Falcons

5 Posts
4 Users
0 Reactions
1,770 Views
Posts: 28
Topic starter
(@tcraft29)
Eminent Member
Joined: 13 years ago
[#44053]

So I ran into a problem with a controller and am just now getting my lights on my house up and running. I have been running my mega tree, some smaller trees and a few other things to keep the show going on. I have resolved my issue with my other controller and am looking to hook up my second controller to control my lights on my house.

A few questions:

Since it is two different controllers with two separate ip's do I set it up in unicast or multicast?

If it is multicast do I just program the strings on my second falcon to start on the next number? For example, if my first falcon ends on 2448, the first node on my second falcon would be 2449? Will it just pick up the second controller and know where that node is?

I guess the same question would apply if I do unicast, after I set my ip's in xlights do I number the lights like my question above?

Just a little confused. Thanks for any input.


4 Replies
Posts: 128
(@emuney18)
Estimable Member
Joined: 11 years ago
tcraft29 wrote:So I ran into a problem with a controller and am just now getting my lights on my house up and running. I have been running my mega tree, some smaller trees and a few other things to keep the show going on. I have resolved my issue with my other controller and am looking to hook up my second controller to control my lights on my house.

A few questions:

Since it is two different controllers with two separate ip's do I set it up in unicast or multicast?

If it is multicast do I just program the strings on my second falcon to start on the next number? For example, if my first falcon ends on 2448, the first node on my second falcon would be 2449? Will it just pick up the second controller and know where that node is?

I guess the same question would apply if I do unicast, after I set my ip's in xlights do I number the lights like my question above?

Just a little confused. Thanks for any input.

You can do multicast which is my setup with 2 Falcons. Just set your channels in the Falcon interface and select absolute channel numbers to match the Xlights numbers.

Sent from my iPhone using Tapatalk


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

I like using unicast. For me, I like that I only send the data that is used by each specific controller instead of broadcasting all the data out.


Reply
Posts: 326
(@jsheehan3)
Honorable Member
Joined: 17 years ago
Emuney18 wrote:You can do multicast which is my setup with 2 Falcons. Just set your channels in the Falcon interface and select absolute channel numbers to match the Xlights numbers.

Sent from my iPhone using Tapatalk

When you say set channels to numbers to match xlights - does that mean if I use 1-5000 on controller 1 begin controller 2 with 5001 in absolute mode?

Haven't tried this but this would make things easier.

Sent from my iPhone using Tapatalk


Reply
Posts: 128
(@emuney18)
Estimable Member
Joined: 11 years ago
jsheehan3 wrote:When you say set channels to numbers to match xlights - does that mean if I use 1-5000 on controller 1 begin controller 2 with 5001 in absolute mode?

Haven't tried this but this would make things easier.

Sent from my iPhone using Tapatalk

Yes. You don't need all channels from 1-5000 used you only need your elements to have numbers in the specific range for each controller.

Sent from my iPhone using Tapatalk


Reply
Share: