Unicast question
 
Notifications
Clear all

Unicast question

12 Posts
5 Users
0 Reactions
5,225 Views
Posts: 210
(@gadgetsmith)
Estimable Member
Joined: 13 years ago

I'd go back to the beginning.

Turn on only one controller with universes 1-12. Controller 192.168.1.110

Test that your string of 50 pixels work via the 6804 test sequences.

Verify that this IP is not in conflict with something else on your network.

Use test tab on xlights to see if pixels are responding (enable only channels 1 - 510) be sure output is enabled on xlights.

From there, create models, and a little sequence and test.

Turn off first controller, then test second controller in a similar manner, changing universes and selecting channels as necessary.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
gadgetsmith wrote:I'd go back to the beginning.

Turn on only one controller with universes 1-12. Controller 192.168.1.110

Test that your string of 50 pixels work via the 6804 test sequences.

Verify that this IP is not in conflict with something else on your network.

Use test tab on xlights to see if pixels are responding (enable only channels 1 - 510) be sure output is enabled on xlights.

From there, create models, and a little sequence and test.

Turn off first controller, then test second controller in a similar manner, changing universes and selecting channels as necessary.

Agree 100% - test each separately since that will clearly break where your issue is - if each work by themselves, then you know it's something on the PC/sequencer side of things.

Also - lol... create a new set of screen shots of each controller again and keep the IPs set.


Reply
Page 3 / 3
Share: