Hi all
I made myself a jiffy box tester that when connected shows voltage and amps. My intention was to use it to measure the current draw from each controller port. My logic was that I would theoretically work out the current draw based on number of pixels and current per pixel and then also test to ensure it was correct.
It gets a little bit less simple than that when you add power injection. So I am using a distribution/power board for my power injection so testing current draw off the controller port isn't all that's needed is it.
My set up is from my power supply using 16awg to my fused distribution board and one output from this then provides power to my kulp controller.
I am not certain of the best way to fuse things also. The kulp controller has 5a fuses per output and the fused distribution board has whatever amperage fuses I choose to use.
What is the best method to test the current draw and ensure I have the correct fusing so if one fails the rest of the display isn't carrying the entire current?
, I am using a method I saw on a bill porter tutorial where I use the same power output wire to power inject in 4 places and read that 16awg wire can handle sufficient current to power inject in 5 places so that should allow a little margin for error.
Any help would be appreciated. If anything is not clear please let me know.
Thanks all

