Notifications
Clear all
Nov 13, 2012 11:32 pm
I have 12v pixel modules from ray wu I just built and set up my e682 I have been running the test patterns and when I change pattern nothing happens but if I unplug string and plug it back in it will show the correct pattern. What's going on I tested some pixel strings with same chip. And they worked fine though not the same cluster though I'm running 5v and 12v and the strings are 5v
Sent from my iPhone using Tapatalk
2 Replies
Nov 14, 2012 5:30 pm
I had issue with half of my pixels doing that with ray pixels on the ones that the wire goes straight into pixel not from back. The data wires are not making good contact.
Nov 14, 2012 5:39 pm
Depending on where they're plugged in it may take a while for the test pattern to reach them.
