I am running a Kulp 16A-B as my main controller and two differential receivers ("dumb" receivers from Wizard of Wire); one for the mega tree and another for the snowglobe (each has its own power supply). I have everything on a smart plug and I run a shutdown script on the Kulp before cutting the power at the end of the night.
When I power up the system (no sequence running), the megatree has odd pixels lit up (see picture) and I have to reboot that tree/differential receiver - then it works fine (I can just unplug the extension cord for that). The next day, the same thing happens. The lights are still up right now, but I will start tearing things down soon.
Any suggestions on what to look for?
It's different every time but looks similar or it is exactly the same?
Do you power up the differential receiver before, at the same time or after the kulp?
You can't just send "all off" and fix it?
You did not mention whether the pixels behave properly if you start playing a sequence. If they work properly without a reboot then this is just noise on the data wires. Play an all off sequence or set the controller to "always send data".
MikeKrebs wrote:It's different every time but looks similar or it is exactly the same?Do you power up the differential receiver before, at the same time or after the kulp?
You can't just send "all off" and fix it?
I power up both the Kulp and diff. at the same time (on the same smart plug). The diff/tree does not respond to anything - test mode does nothing, playing a sequence does nothing. Once I kill the power and plug it back in (or turn off/on the smart plug) then it works properly.
and the pixels that are lit are different each time (looking at it right now, comparing my photo)

