Simple wiring quest...
 
Notifications
Clear all

Simple wiring question

3 Posts
2 Users
0 Reactions
1,281 Views
Posts: 94
Topic starter
(@diyermaker)
Estimable Member
Joined: 6 years ago
[#54452]

I have a very small controller, I am wondering if I can have 2 arches on one channel. Will it be easy to sequence or should they be different channels? Thanks!


2 Replies
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Short answer:
Yes you can have both arches on a single output port.

Long answer:
The output ports on your controller have very little to do with how you sequence a prop. Both xLights and Vixen use a patching mechanism to convert your props in a sequence to data channels your controller can send out of ports. That patching assigns your props to a set of channels. Your controller configuration assigns a set of channels to an output port. Notice the non-existent connection between the sequenced prop and the physical prop?

With proper power injection, you can have a lot of pixels connected to an output port. Some of the limiting factors on the number of pixels you can put on a single output port is:

  • Refresh speed.
  • WS2811 pixels running at 25ms refresh speed limits you to 680 pixels on the string
  • WS2811 pixels running at 50ms refresh speed limits you to 1360 pixels on the string

Controller capacity. Your controller will have a definition for max pixels per output port


Reply
Posts: 94
Topic starter
(@diyermaker)
Estimable Member
Joined: 6 years ago

Thanks! I only have about 100 pixels on the arches so that should work no problem.


Reply
Share: