Simple Power Inject...
 
Notifications
Clear all

Simple Power Injection Test Tool

4 Posts
4 Users
0 Reactions
1,727 Views
jklingert
Posts: 1767
Topic starter
(@jklingert)
Noble Member
Joined: 16 years ago
[#38939]

Here is a simple way to test your voltage levels at the beginning or the end of a connectorized pixel string. All you need is a pair of male and female connectors, cut them short so that the extra wire does not cause additional voltage drop and a low cost 3 - 30V volt meter like this or this. No need to cut into the power wires or shrink wrap to test, just insert inline and you can read the voltage easily.



power1
power2
power3

3 Replies
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

Great idea!!! And low cost. Too bad I used different connectors on different props to make it Murphy proof. We'll maybe Murphy resistant.


Reply
DrNeutron
Posts: 2018
(@drneutron)
Noble Member
Joined: 14 years ago
Skunberg wrote:Great idea!!! And low cost. Too bad I used different connectors on different props to make it Murphy proof. We'll maybe Murphy resistant.

My Murphy is a MacGyver....or MurGyver! No matter what I do the darn fellow finds a way to mess things up.
:biggrin:


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Pretty clever there Jack - I've seen those modules for dirt cheap so this would not be an expensive addition.


Reply
Share: