I have halogen floor embedded lights to light the walls on my house like the ones on the next picture:
A few days ago I thought to change the bulbs to LED lights, but after thinking for a while i came with the idea of replacing them with a high power RGB Led and be able to control them to make simple color changes and effects. But I can't run new wire to the the enclosures of the lights to run RGB individually so I thought if it would be possible to use the 3 existing wires (Phase, Neutral and Earth) to use them as +12V, Ground and Data and control the lights as if they where an RGB Pixel.
My idea is to find a board to drive the RGB LED that uses a digital control system and if possible with a parallel protocol so i don't need to link data input and output of the different lights (In case of being serial I could split all the earths individually and then i could use as much controllers as nodes to run in parallel)
I've been looking on the internet and the forum for something that could be adapted to this use and I can't find anything.
Anyone knows any system/board/DIY solution that could be adapted to this use?

