SanDevice E682's & ...
 
Notifications
Clear all

SanDevice E682's & resistors

2 Posts
2 Users
0 Reactions
1,068 Views
Posts: 15
Topic starter
(@gex598)
Eminent Member
Joined: 13 years ago
[#53144]

Learned something new tonight about E682's. I've purchased a few fully assembled from SanDevice directly and have never had any issues with the cable runs (no flickering pixels). Last week I purchased a two E682's from a member who brought up resistors too me and that he had switched them from the default 270's to 33's. I wasn't sure what this meant but to air on the side of safety he swapped the 270's back in before shipping. Fast forward to tonight, I hooked up one of the boards I just purchased and started getting flickering on every pixel set I plugged in. I then took the data cable and pixels outside to some of the controllers in the show and tested and it worked fine. Lucky for me I remembered the discussion on the resistors and swapped in one of the 33's onto the board inside.....everything worked perfect. What I learned is that if you purchased an assembled E682 the board ships with 150ohm resistors on it, if you purchase a kit you get 270ohm resistors.

Thanks to @rayhjr for educating me on resistors on the E682's. Learned something handy if I ever need to get a few extra feet to a prop and do not want to run a null pixel.


1 Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago

Not just distance. It you have not seen this I think it is the best thing since sliced bread!

It's long but somewhere in there Keith talks about 33 ohm resistors.

Sent from my SM-A505U using Tapatalk


Reply
Share: