Notifications
Clear all

rays pixels

109 Posts
36 Users
0 Reactions
27.7 K Views
Posts: 1792
(@barbotte)
Noble Member
Joined: 17 years ago
angus40 wrote:It is a good thing you are burning them in now Henri , By Dec. you will have all issues fixed .

The down side to a pvc tree / climbing up and down .

With the straping system and trailer/hand crank winch repairs is a bit simpler as you can lower the entire works.

I hope you created a couple spare complete pvc runs for a simple swap out , then you could do the repairs on the troubled run at your convenience

well my show is on from 10 am till 3 pm and it will be like that until probaly next week so before i clinmb i what to make sure the rest are good ....cheer


Reply
Posts: 2168
(@djulien)
Noble Member
Joined: 19 years ago
barbotte wrote:well i bough 2000 pixel this year .... i put my tree up ,,, and 24 hours later . 1 string fail .... righ dead center of it too so it need to be replace ,,,,
boarder3 wrote:Now the pixels from year before are failing everywhere. All these pixels are the better 3001 pixels.

@barbotte + @boarder3,

What type of body were the pixels? (the "bullets", square, or other?) Also, how did you have them mounted/strung? (free standing strings, or fastened to strapping of some kind, etc)

don


Reply
Posts: 1792
(@barbotte)
Noble Member
Joined: 17 years ago
djulien wrote:@barbotte + @boarder3,

What type of body were the pixels? (the "bullets", square, or other?) Also, how did you have them mounted/strung? (free standing strings, or fastened to strapping of some kind, etc)

don

mine were the better one the square pixel with the wire comming out almost in the back ... and they are mounted on emt pipe no they are not free standing ...cheer


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

Do you think This has any thing to do with poor- sub standard solder they are using ?

I noticed the tinned -solder on the waterproof connectors I recieved was very milky looking , so I re-solder all of them prior to use

kinda like a re- tinning . just a thought.


Reply
Posts: 238
(@ronp5683)
Reputable Member
Joined: 14 years ago

At least Ray uses leaded solder. Quality is a hard thing and depends heavily on training. The best bet for quality is the strips which are machine placed and soldered, but always order spares.

There are enough people on this forum, you could do your own pixel strips and solder them yourselves. That way you only have yourself to blame for quality, but you will know how to repair them.


Reply
Page 3 / 22
Share: